The wire drawing machine system has a high demand for speed control. For a mechanical equipment wire drawing machine manufacturer, this control system can provide a very accurate and lubricated line speed. The wire drawing machine is used for general plastic wire drawing machines to meet higher demands for pulling gold wires. The entire system is quite complex, requiring coordination between various motors to control the equipment. The system is controlled by four servo motors and supported by Kinco servo bus communication, which fully satisfies the real-time interaction between data and the servo steel bar straightening and cutting machine for real-time data exchange between each axis of each group.

In the system view of the interaction between the shafts of the high-speed motor, in order to ensure that the wires in the required row can be quickly calculated according to the local trajectory side lines of the algorithm, we also make full use of the servo internal firmware function KINCO, which is calculated by the driver itself and drives the motor wires, greatly eliminating the need for the traditional wire drawing machine control system to calculate the direction of the wires. Then, due to time delay, it is sent to the driver to ensure that the wires pass through the controller as much as possible.

Article source: Jiangmen Wire Drawing Factory http://www.bzcpm.com